Starting And Shutting Down The Projector - BOXLIGHT Broad View User Manual

Starting and Shutting down the Projector

1.
Connect the power cord to the projector.
Connect the other end to a wall outlet.
The POWER and READY LEDs on the
projector turn on.
2.
Turn on the connected devices.
3.
Ensure the Ready LED is on a steady (not
flashing) orange and then press the Power
button to turn on the projector.
The projector splash screen displays and
connected devices are detected.
If the connected device is a PC, press the
appropriate keys on the computer
keyboard to switch the display output to
the projector. (Check the user manual of
the PC to determine the appropriate Fn
key combination to change display
output.)
See "Setting an Access Password
(Security Lock)" on page 12 if Security
Lock is enabled.
4.
If more than one input device is
connected, press the Source button
repeatedly to switch among devices.
(DVD and HDTV are supported through
the DVI-I connector.)
5.
To turn off the projector, press the Power
button. The projector prepares for
shutdown and a "Wait a moment
please..." message appears.
6.
When the "Power Off?/Press Power again"
message appears, press the Power button.
The projector turns off.
Caution:
Do not unplug the power cord until the Ready LED stops flashing, indicating the projector has
cooled down.
D
D
D
– 11 –
L P P r o j e c t o r – U s e
L P P r o j e c t o r – U s e
L P P r o j e c t o r – U s e
r ' s M a n u a l
r ' s M a n u a l
r ' s M a n u a l