Replacing the Projection Lamp
The projection lamp should be replaced when it burns out. It should only be replaced with a certified
replacement part, which you can order from your local dealer.
Important:
1. The lamp contains a certain amount of mercury and should be disposed of according to local
ordinance regulations.
2. Avoid touching the glass surface of the new lamp: Doing so may shorten its operation life.
Warning:
Be sure to turn off and unplug the projector at least an hour before replacing the lamp. Failure to do
so could result in a severe burn.
1.
Loosen the two captive
screws on the lamp
compartment cover (A).
2.
Remove the lamp
compartment cover (B).
M
AINTENANCE AND
A
– 28 –
S
ECURITY
B
A
Need help?
Do you have a question about the Broad View and is the answer not in the manual?