Shutting down the projector Troubleshooting your setup Table 1: LED behavior and meaning LED color/behavior Meaning solid green The projector is plugged in, or the projec- tor has been turned on and the software has initialized. The projector has been turned off and the fans have stopped.
Problem Solution Result plug power cord in remove lens cap press power button no start up screen correct image startup screen computer image projected only start up screen appears press the computer button activate laptop’s external port startup screen restart laptop...
Page 14
Problem Solution Result no computer image, just the words “Signal out of press the auto image button on keypad computer image projected range” Adjust computer refresh rate in Control Panel>Display>Settings>Advanced>Adapter (location varies by operating system) You may also need to set a different resolution on your computer, as shown in the following problem, “image fuzzy or cropped.”...
Page 15
(Start>Settings>Control Panel>Display>Settings tab, select 800x600 for the SP-45m, 1024x768 for XP-55m) For a laptop, disable laptop monitor or turn-on dual- display mode...
Page 16
move projector, adjust zoom, adjust height image not centered on screen correct image zoom adjust horizontal or vertical position in Picture>Advanced menu square image adjust keystone on keypad image not square...
Page 17
adjust Sharpness in the Picture>Advanced correct image menu image not sharp change aspect ratio to 16:9 in correct image Picture>Aspect ratio menu image does not fit 16:9 screen correct image turn off Ceiling in Settings>System menu image upside down...
Page 18
image reversed left to right turn off Rear in Settings>System menu correct image adjust color, tint, color temperature, brightness, contrast in the menus projected colors don’t match source correct image COLOR COLOR make sure vents aren’t blocked, turn off the projector and allow it to cool for a minute lamp won’t turn on, LED blinking red lamp turns on...
Page 19
If lamp hours > 2000, lamp must be lamp won’t turn on, LED blinking red, “Change replaced. See page 31. lamp turns on lamp” message appears at startup blinks red startup screen check lamp hours...
Using the remote control backlight button cursor control mouse buttons menu navigation menu buttons select Troubleshooting the remote power volume mute video computer blank effect...
Settings menu Sources>Start up Source: Sources Autosource Settings menu computer video Start up Source System Rear: Ceiling System menu Display Messages Power Save power Screen Save...
Page 29
Start up logo Blank screen Start up logo Blank Screen blank Effect effect select Effect effect effect...
Page 30
PiP size Picture in Picture PiP Position Language Language Service Factory Reset Reset Lamp Service menu Service Info Service Code About About menu effect...
Replacing the Projection Lamp Lamp hours used NOTE 60 minutes CAUTION...
Page 33
WARNING WARNING WARNING power Cleaning the Lamp Housing Screens Service menu...
Page 34
User’s Guide Safety card 4.9 - 29 feet (1.5 - 8.9 m) Optics Focus Range 132-watt UHP lamp for SP-45m Lamp type 150-watt UHP lamp for XP-55m Input Power Requirements 100-240V 2.5-1 A, 50-60 Hz Ceiling Mount UL tested/listed ceiling mount with minimum capacity of...
Various Wall/Ceiling Mounted Screens 200/5.1 160/4.1 29.2/8.9 24/7.3 Portable Projector Stand 7DEOH Replacement Lamp Module for SP-45m 5DQJH RI GLVWDQ.H WR WKH V.UHHQ IRU D JLYHQ V.UHHQ VL]H IRU ;3P Replacement Lamp Module for XP-55m Presentation Remote Distance to screen Diagonal Maximum...
Page 36
LIMITED WARRANTY DISCLAIMER OF UNSTATED WARRANTIES LIMITATION OF LIABILITY A return authorization number, issued by the B customer service department, OXLIGHT must also be clearly displayed on the outside of the shipping carton containing the Product. WARRANTY LIMITATION AND EXCLUSION...
Page 37
SP-45m/XP-55m Boxlight 19332 Powder Hill Place Poulsbo, WA 98370-7407 USA www.boxlight.com U.S.A. and Canada 800-762-5757 International 360-779-7901 ™ BOXLIGHT CORPORA TION...