Connect Vent; Level Dryer - Maytag MGD8000AW0 Installation Instructions Manual

CONNECT
VENT
1, Connect vent to exhaust outlet
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
2, Move dryer to final location
LEVEL DRYER
1, Level dryer
Place
level here
mm
Check levelness of dryer from
side to side. Repeat from front to back.
©
NOTE: The dryer must be level for the moisture sensing system
to operate correctly
Not Level LEVEL Not Level
2, Adjust leveling legs
Move dryer to final location, taking care not to crush or
kink vent or flexible gas line.
After dryer is in place, remove corner posts and cardboard
from under dryer.
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the floor and the dryer does not rock.
14