Alarm Config Page; Figure 3.12: Dtv 720 Alarm Configuration Page - Wegener DTV 720 User Manual

will not cause a switch. The
setup on the
cause a switch if that condition is configured as an
Once the
on its front panel LCD screen and on the
in a
is up to the user to verify that the condition that caused the switch has cleared. Then the
unit can be manually switched back to its former configuration.
The
Alarm Config
as an
Page
Alarm
The
tion
uration in the event of a signal source problem. By default, all events are set to be in an
Alarm
Table 3.3
Warnings, with a brief description of each type of event and what it applies to..
www.wegener.com
Alarm Configuration Page
unit has switched to a
DTV 720
mode. The unit will not automatically recover from this switch. It
Backup Configuration
page allows the user to configure whether an event type will be handled
Alarm Config
or condition or whether the event type will be disabled so that no
Alarm Warning
or indications will be given for that specific type of event. (See
Warning
Figure 3.12: DTV 720 Alarm Configuration Page
page should be used in conjunction with the
Alarm Configuration
, under
Unit Configuration
condition.
on the next page lists all the types of events that can be configured for Alarms or
condition that will cause such a switch is defined by the-
Alarm
. Any of the 21 conditions listed on this page will
Alarm
Backup Configuration
Control & Status
page, to set up the
DTV 720
21
DTV 720 U ' M
SER S
.
, a warning will be displayed
page, indicating that the unit is
Figure 3.12
Backup Configura-
unit to switch to another config-
800043-01 Rev. C
ANUAL
.)