Figure 3.25: Tftpd Server Tab With File Transfer Progress Bar - Wegener DTV 720 User Manual

DTV 720 U ' M
SER S ANUAL
8. Connect the computer directly to your
NOTE:
9. Power up the
10. Press the s s arrow key
NOTE:
11. Two options will appear on the LCD:
12. Watch the progress of the file transfer by selecting the
13. When the file transfer is complete, the progress bar disappears, and the file transfer
14. The
15. After the unit resets, verify that the correct code has been loaded by pressing
16. After all units have been upgraded,
800043-01 Rev. C
Do not connect over a network.
and you should see on the front-panel LCD the message,
DTV 720
.
any key to stop boot
immediately
.
Mode
This screen is set to time-out after two seconds. You must act quickly.
Press . The upgrade transfer will start and lasts only about three seconds.
ENT
main screen. A Progress bar showing the status of the ongoing transfer pops up as
shown in below.
Figure3.25
Figure 3.25: TFTPD32 Server Tab with File Transfer Progress Bar
log can be read on the Tftp Server tab, as shown in
will automatically restart when the transfer is completed and written to
DTV 720
flash.
checking that the version number matches the
and folders used in this upgrade from your hard drive.
using a LAN crossover cable.
DTV 720
to interrupt the
Boot Loader
ress ENT to upgrade
P
Tftp server
Progress bar showing file transfer.
Note, it will only be on the screen
for about 3 seconds.
Figure 3.26
in the
xxx
recommends that you delete all the files
Wegener
40
Hit
and enter the
Upgrade
and
Press ESC to quit
tab on the
TFTPD32
below.
ENT
file.
DTV 720-xxx.cf
www.wegener.com
.
and