Lan Connection; Using The Web Browser; Table 3.2: Pc Ip Setup - Wegener DTV 720 User Manual

DTV 720 U ' M
SER S ANUAL
For LAN connection, attach the
LAN
straight-through, RJ-45 cable. Set the
Connection
directed by your network administrator. Use any PC on the LAN to connect to the
using the web browser instructions below.
NOTE:
To begin
Using the
Web Browser
NOTE:
The
Configuration
by clicking the appropriate tab for each at the top of the screen.
Normally you will first select the
and
included in the output (by either channel name or program number), assign new program
numbers if desired, change the major/minor channel number, change the channel name,
and select the audio to be included in each program's output. Next, select the
page to verify that the input and output data are configured as intended
Finally, you may select the
multiple configurations that you use from time to time, you may now set them up using the
same steps as above. After the initial setup, it will be easy to select various stored config-
urations from the
description of each screen.
800043-01 Rev. C

Table 3.2: PC IP Setup

Parameter
IP Address
Netmask
Gateway
Each unit on the network must have a unique address.
DTV 720
monitor and control functions from a PC or LAN connection:
DTV 720
a. Open the current internet browser of your choice from the local PC or computer on
the LAN attached to your
b. Set the browser's address field to http://nnn.nnn.nnn.nnn where nnn.nnn.nnn.nnn
is the IP address of the unit to be controlled (set from the
Address screen).
For IP addresses which include subfields with leading zeros, you must omit those
zeros when entering the address in your browser. For example, IP address
128.092.050.004 must be entered as 128.92.50.4.
DTV 720 Control and Status
, ,
Alarm Config
characteristics. Use the
COMPEL
Unit Configuration
Unit Configuration
Setting
172.016.100.020
255.255.000.000
000.000.000.000
's Ethernet port to the LAN using a normal,
DTV 720
IP Address, Netmask, and Gateway as
DTV 720
.
DTV 720
page will appear. You may select the
,
Pidsets Config Module Config
page to select the input, output, control,
Control & Status
Pidsets Config
screen to save the configuration. If you have
screen. The following paragraphs give a detailed
14
's front-panel, IP
DTV 720
Stream Info
, or pages at any time
Q&A/Help
page to select programs to be
www.wegener.com
DTV 720
,
Unit
Stream Info