Stream Information Page; Unit Configuration Page; Figure 3.9: Dtv 720 Stream Information Page - Wegener DTV 720 User Manual

The Stream Information page (see
Stream
streams and the output stream. This is for reference only. No selections may be made on
Information
this page. The left side shows input information and the right side shows output informa-
Page
tion.
Input
All input streams are shown whether or not they are selected for the output. Information
provided for each active input includes the Pogram Short Name; Major and Minor channel
numbers; Program Number with PMT and PCR PID locations indicated; and a list of all
referenced streams (video, audio, and data) with their PID numbers. Any PIDs present
that are not referenced are shown as
Output
of each output program.
Unit The
stored with a user-selected name. A stored configuration may be loaded at any time to
Configuration
rapidly change the configuration of the unit. Using
Page
could be loaded with the configurations of several on-line units. Then, in the unusual case
of failure of an on-line unit, the backup could be installed with the correct unit configuration
already loaded. With up to twenty characters allowed for each configuration name, highly
descriptive naming may be used.
www.wegener.com
Figure 3.9:
information begins with
information provides the same information as the Input side plus the input source
, shown in

Unit Configuration Page

) gives detailed information on all input
Figure 3.9
DTV 720 Stream Information Page
followed by
ASI Input 1 ASI Input 2
.
Ghost PIDs
, allows the multiplex configuration to be
Figure 3.10
Unit Configuration
19
DTV 720 U ' M
SER S ANUAL
, , and
RF Input 1 RF Input 2
, a single backup unit
800043-01 Rev. C
.