Download Print this page

Installation Requirements - KitchenAid KBHS109SSS04 Installation Instructions Manual

27" (68.6 cm) and 30" (76.2 cm) electric built-in microwave oven
Hide thumbs Also See for KBHS109SSS04:

Advertisement

Available languages

Available languages

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools needed
Philips screwdriver
Measuring tape
Level
Hand or electric drill (for wall
cabinet installtions)
1" (25 mm) drill bit (for wall
cabinet installations)
Parts needed
A UL listed or CSA approved conduit connector
UL listed wire connectors
Parts supplied
2 screws
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
It is recommended
that all electrical connections
be made by a
licensed, qualified electrical installer.
IMPORTANT"Observe all governing codes and ordinances.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with
microwave oven.
Recessed installation area must provide complete
enclosure
around the recessed portion of the microwave oven.
Grounded electrical supply is required. See "Electrical
Requirements"
section.
Electrical supply junction box should be located 3" (7.6 cm)
maximum below the support surface when the microwave
oven is installed in a wall cabinet. A 1" (2.5 cm) minimum
diameter hole should have been drilled in the right rear or left
rear corner of the support surface to pass the appliance cable
through to the junction box.
NOTE: For undercounter
installation, it is recommended
that
the junction box be located in the adjacent right or left
cabinet. If you are installing the junction box on rear wall
behind the microwave oven, the junction box must be
recessed and located in the upper or lower right or left corner
of the cabinet; otherwise, the microwave oven will not fit into
the cabinet opening.
Microwave oven support surface must be solid, level and
flush with bottom of cabinet cutout. Floor must be able to
support a weight of 110 Ibs (50.0 kg).
Product Dimensions
27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens
27" (68.6 cm) models
A. 25_8" (64.3 cm) recessed
width
B. 20_£' (51.6 cm) overall height
C. 26_" (67.9 cm) overall width
D. 23" (58.3 cm) max. recessed
depth
E. 18_" (47.6 cm) recessed
height
30" ('76.2 cm) models
A. 28_?' (71.9 cm) recessed
width
B. 20_£' (51.6 cm) overall height
C. 29_" (75.6 cm) overall width
D. 23" (58.3 cm) max. recessed
depth
E. 18_" (47.6 cm) recessed
height
Cabinet
Requirements
27" (68.6 cm) and 30" (76.2 cm) Microwave Ovens
_A
B
F
_D
C
Y
27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout to
bottom of upper cabinet door
C. 4_' (101.2 cm) bottom of
cutout to floor (recommended)
D. 25 _" (64.8 cm) cutout width
E. 1_" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. !9_/'
(49.4 cm) cutout height
30" (76.2 cm) models
A. 30" (76.2 cm) min. cabinet
width
B. 1" (2.5 cm) top of cutout to
bottom of upper cabinet door
C. 4_' (101.2 cm) bottom of
cutout to floor (recommended)
D. 28 _" (72.4 cm) cutout width
E. 1 ½" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. !9_"
(49.4 cm) cutout height

Advertisement

loading