Table of Contents
Advertisement
Available languages
Available languages
BUILT-INMICROWAVE/OVEN COMBINATION SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
You can be killed or seriously injured if you don't immediately
follow
instructions.
You can be killed or seriously injured if you don't follow
instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions
provided with any tools listed
here.
Tools Needed
•
Phillips screwdriver
•
Measuring tape
•
Drill (for wall cabinet installations)
•
1" (2.5 cm) drill bit (for wall cabinet installations)
•
Level
•
Flat-blade screwdriver
Parts Needed
•
UL listed or CSA approved conduit connector
•
UL listed wire connectors
Warming Drawer Deflector Kit (for ovens installed above a
warming drawer)
Order Part Number W10489566B
for white 27" (68.6 cm) kit
Order Part Number W10489564B
for black 27" (68.6 cm) kit
Order Part Number W10489568A
for stainless steel 27"
(68.6 cm) kit
Order Part Number W10489567B
for white 30" (76.2 cm) kit
Order Part Number W10489565B
for black 30" (76.2 cm) kit
Order Part Number W10489569A
for stainless steel 30"
(76.2 cm) kit
Order Part Number W10727416A for stainless steel/black 30"
(76.2 cm) kit
To order, see the "Assistance
or Service" section of the Use
and Care Guide.
Flush Installation Kit (for Combo installed at flush installation)
Order Part Number W10752694A
for white 27" (68.6 cm) kit
Order Part Number W10752695A
for black 27" (68.6 cm) kit
Order Part Number W10752696A
for stainless steel 27"
(68.6 cm) kit
Order Part Number W10752687A
for white 30" (76.2 cm) kit
Order Part Number W10752688A
for black 30" (76.2 cm) kit
Order Part Number W10752693A
for stainless steel 30"
(76.2 cm) kit
Order Part Number W10752691A for blacWstainless
steel 30"
(76.2 cm) kit
To order, see the "Assistance
or Service" section of the Use
and Care Guide.
Parts Supplied
•
#8-14 x 1" screws (4)
•
Bottom vent
•
#8-18 x 3/8"screws - bottom vent (2)
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
It is recommended
that all electrical connections
be made by a
licensed, qualified electrical installer.
IMPORTANT: Observe all governing codes and ordinances.
•
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
•
Recessed installation area must provide complete
enclosure
around the recessed portion of the oven.
•
Grounded electrical supply is required. See "Electrical
Requirements"
section.
2
Advertisement
Table of Contents
