Install Decorative Top Panel - KitchenAid KSSC42QMS02 Installation Manual

7. Replace the door stop screw and tighten.
8. Make final recheck to make sure the doors are aligned and
even.
Door Swing Adjustment
1. Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw from the bottom
hinge. Hold the door open to a position that is less than 90 °.
2. Replace the door stop screw in the bottom hinge and tighten
the screw.
Side by Side:
Replace the door stop screw in the 110 ° or 90 ° door stop
position.
Adding a Decorative Panel to the Top Grille Assembly
1. Grasp both ends of the top grille assembly.
2. Push top grille assembly frame straight up, then pull straight
out. Lay assembly on soft surface.
3. Remove nuts and side trim from right side of the top grille
assembly frame. Insert decorative panel into frame. Reattach
side trim and nuts.
2 3
!. 130°position
2. 110 ° position
3. 90 ° position
Bottom Mount:
Replace the door stop screw in the 90 ° door stop position.
1. Nuts
2. Top grille side trim
Reattach top grille assembly by inserting hooks (located on
the back of the top grille) into the slots on the side trim. Pull
panel down slightly to lock into place.
2
1 2
1. 130°position
2. 90 ° position
If the door does not clear countertop after the door has been
adjusted, the countertops may have to be mitered.
1. Top grille
2. Cabinet side trim
IMPORTANT: KitchenAid is not responsible for the removal or
addition of molding or decorative panels that would prevent the
refrigerator from being serviced.
18