Product Dimensions; Door Swing Dimensions - KitchenAid KSSP36QMS02 Installation Manual

NOTE: When creating a panel with face detail, the offsets will be
hidden and must be accounted for in order to center the detail in
the top grille.
_[_ 1/4"
(6.35 mm) max.
-y
1/2" Top
(1.3 cm)
min,
Center face
detail between _'_'--,-..__
offsets
3/8" ]
(9.5mm)
min, Bottom
_
_-- I/4''
--(6.35
mm)max.
Door Panels - Routing Requirements
If the custom panels are thicker than 1/4"(6.35 mm), then all edges
of the panels must be routed. If the standard handle is used,
route the entire handle side of both panels 31/4 '' (8.25 cm) to allow
for finger clearance. Then route the other sides 1" (2.54 cm).
Standard Handle - Top View
d)
_3
-r-
31/4 ''
(8.26 cm)
rain.
= t
/
1/4" (6.36 mm) max, |
|
2" (5 cm)
rain.
Door
Panel
Hinge Side
__J
Door IJ
Panel
1 "
(2.54 cm)
If an extended handle kit is used, route the handle side 1/4"
(6.35 mm). All other routing dimensions would remain the same
as the standard handle. Make sure your product location will
allow doors with extended handles to be opened to 90 degrees.
See "Door Swing Dimensions."
For more information on ordering extended handles, see "Classic
Series Factory Panels and Kits."
NOTE: For both types of handles, route the top and bottom
edges W' (1.3 cm).
Door Panel - Side View
C
Q_
Extended Handle - Top View
i 1/4, '
4<[--- (6.35 mm)
® _-_ Door
Panel
!
1"
(2.54 cm)
max
Hinge Side
Door
r--]l
1 "
(2.54 cm)
C_ sk:}!_:_Side f%m,e s
Custom side pane[s may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset, Flush, or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type
of installation you are planning.
NOTES:
• The dimensions shown are actual product dimensions
and may not reflect the needed panel installation
dimensions.
• The side panel should be a minimum of 1/2"(1.3 cm) thick
to prevent warping.
• If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on rear wall.
Refrigerator
't
241/s.
(61,3 cm)
J 2311/1e, '
(60,3 ore)
231/2 ''
(59,7 cm)
e
16