Pc Display; Replenishing Paper; Removing A Paper Misfeed - Minolta CSPRO EP1031 Manual

2. PC Display

Replenishing Paper

Pull out the paper drawer and push down
1
on the paper lifting plate until it is locked
into position.
Load the paper stack into the drawer.
2
Make sure that the paper stack rests under
the two catches of the drawer.
NOTE
Max.
C1159O067DA
Adjust the paper guide plates and gently
3
return the drawer to the copier. Press the
Clear/Stop Key.
NOTE
For details on supplying paper using the Multi
Bypass Tray, refer to page 19.
The PC display means that the Paper Drawer has run out of
paper or there is a paper misfeed at the paper feed area.
The following are the procedures for replenishing paper and
clearing a paper misfeed at the paper feed area.
C1159O064DA
C1159O065DA
C1159O066DA
Never exceed the
mark indicating
maximum capacity.
C1159O068DA

Removing a Paper Misfeed

Open the Right Door and remove the
1
paper misfeed.
Open the drawer, remove the paper and
2
push the paper lifting plate down.
Fan the paper and reload it. Gently slide
3
the Drawer back in.
Press the Clear/Stop Key.
4
NOTE
If PC appears, during the multi copy cycle,
check the copies on the Copy Tray and return the
originals needed to the Document Feed Tray to
complete the copy job.
31
C1159O070DA
C1159O065DA
C1159O066DA