Minolta PAGEPRO L Manual page 194

Improving Print Quality
Symptom
Paper wrinkles
during printing.
The print image
is not fixed and
easily smears.
Incorrect image
registration
(lines are bro-
ken or characters
are out of posi-
tion).
The printer takes
too long to out-
put prints.
5-35
Cause
Possible causes
include:
• Paper is not the
proper size.
• Paper is not loaded
properly in the tray.
• The fusing unit
requires replace-
ment.
The paper loaded in
the tray is damp.
The paper being used
is not compatible with
the printer.
The fusing unit
requires replacement.
The print parameters
and paper settings of
the application soft-
ware are different
from the settings on
the control panel.
The printer was in
Power Save mode
when the print com-
mand was issued.
The printer setting
was for color transpar-
ency (transparency
sheet) or thick paper
printing.
The amount of mem-
ory installed is not
sufficient to process
the print data.
Action
Check these conditions
closely and take necessary
action.
• Regarding paper size, see
"Paper" p. 2-19
• See "Loading Paper".
p. 2-23
• See "Changing the Fusing
Unit". p. 4-26
Replace the old paper with
fresh dry paper. p. 2-23
See "Paper" for compatible
types of paper. p. 2-19
Change the fusing unit.
p. 4-23
Make sure that the settings
for the application software
correspond with the control
panel settings, especially
the media options.
Wait a few moments.
Wait a few moments.
Change the Print Media set-
ting in the printer driver.
Install the optional expan-
sion memory, which will
allow the print cycle to run
faster.