Printer Is Printing Blank Pages - Lexmark W01 User Manual

C USB
HECK THE CONNECTION
1
Check the USB cable for any obvious damage. If the cable is damaged, then use a new one.
2
Firmly plug the square end of the USB cable into the back of the printer.
3
Firmly plug the rectangular end of the USB cable into the USB port of the computer.
The USB port is marked with a
Note: If you continue to have problems, then try another USB port on the computer. You may have connected to
a defective port.
R
EMOVE AND REINSTALL THE PRINTER SOFTWARE

Printer is printing blank pages

Blank pages may be caused by improperly installed ink cartridges.
R
EINSTALL THE INK CARTRIDGES AND DEEP CLEAN AND ALIGN THE PRINTHEAD
1
Reinstall the ink cartridges, see "Replacing ink cartridges" on page 14 for more information.
If the cartridges do not seem to fit, make sure the printhead is properly seated, and then try installing the
cartridges again.
2
Load plain paper.
3
From the home screen of the printer control panel, navigate to Deep Clean Printhead:
> More Options > Deep Clean Printhead
A cleaning page prints.
4
Navigate to Align Printer:
> More Options > Align Printer.
An alignment page prints.
Note: Do not remove the alignment page until printing is finished.
Printer is busy or does not respond
If the "Before you troubleshoot" checklist does not solve the problem, then try one or more of the following:
M
AKE SURE THE PRINTER IS NOT IN
If the power light is blinking on and off slowly, then the printer is in Power Saver mode. Press
printer.
If the printer will not come out of Power Saver mode, then reset the power:
1
Unplug the power cord from the wall outlet, and then wait 10 seconds.
2
Insert the power cord into the wall outlet, and then turn on the printer.
If this problem persists, then check our Web site for updates for your printer software or firmware.
USB symbol.
P S
OWER AVER MODE
Troubleshooting
105
to wake up the