Installation Options - GE Monogram ZKD910 Installation Instructions Manual

Installation Preparation
INSTALLATION OPTIONS
Installation Below
a Single Oven
Installation Below
a Double Oven
2x2 or 2x4 Anti-Tip
Block AgainstRear
Wall, g" FromFloor
to Bottom of Block
Allow 5/8"
......... O verlapon
All Sides
23-1/2" Min.
t .... Inside f
2x2 or 2x4 Anti-Tip
BlockAgainst Rear
_Wall, g" FromFloor
to Bottomof Block
Allow 5/8"
Overlapon
/ All Sides
2" Min.
1" Min. AboveToekickor Adjust
to OvenInstallation Height
NOTE:Additionalclearance betweencutoutsmay
be required. C heck to besurethatovensupports
abovetheWarmingDrawerlocationdoesnot obstruct
the required interior23-1/2"depthand9-1/4"height.
1" Min. AboveToekick
Oime.sio.s
A B
ZTDgl0 28-1/2" 30"
ZKDgl0 25-1/2" 26-3/4"
NOTE:Additionalclearance betweencutoutsmay
be required. C heck to besurethat ovensupports
abovethe WarmingDrawerlocationdoesnot obstruct
the required interior23-1/2"depthand9-1/4"height.
When installed under a wall oven:
Warming drawers are approved for installation below onlg
certain specified wall oven models. See the label attached
to the top of the warming drawer for approved models.
• When installed, the front face of the drawer
will be nearlg flush with adjacent cabinetrg doors.
• Drawer overlaps will conceal cut edges
on all sides of the opening.
The rough opening for the drawer must be:
- Depth: 23-1/2" min. from inside back to front
of cabinet frame.
- Width: 25-1/2" for 27" wide models,
28-1/2" for 30" wide models.
- Height: 9-1/4".
- Allow 2" min. between oven and drawer cutouts
for clearance of overlaps.
NOTE: If gou are installing in frameless cabinets, it ma U
be necessarU to install 1/2" wide cleats to accept drawer
mounting screws. See drawer for mounting screw locations.