GE Monogram ZKD910 Installation Instructions Manual page 11

Installation
[STEP 4 I SECURE CUSTOM PANEL
TO METAL MOUNTING PANEL
• Lag the custom panel, appearance side down,
on a clean surface.
• Place the flat side of the metal panel onto the back
side of the custom panel, with the mounting flanges
facing up.
• Align the lamp hole in the panel with the mounting
panel.
Check top, bottom and side overlap dimensions
from the metal panel to wood panel edge as shown.
_ li4" Top
"--1 ° T°
..... Handle ........
] , AttachmentHoles
Align Holes Bottom 7/32"
3/16"
1/4"
Backside of Appearance Panelwith SupportPanel
[ STEP 5 FOR PANELS LESS
THAN 3/4" THICK
• Separate the custom panel and metal panel.
• Apply a few horizontal beads of adhesive
to the metal panel. Avoid adhesive within 1"
of lamp hole area and outer edges.
STEP 5A FOR 314" (OR GREATER}
THICK PANELS
3/4" thick panels may be secured to the metal panel
with screws.
Use the metal panel as a template. Position the metal
panel over the back side of the custom panel and drill
pilot holes. Drill pilot holes sized to match screws being
used (screws not provided).
_4, C AUTION:
Select screw length carefully
to avoid penetration of the finished side.
[ STEP 6 I INSTALL LAMP JEWEL
Turn the assemblg appearance side up.
• Use plastic to wood adhesive to secure the lamp
jewel to the front of the wood panel. On the side
with the bulge, (see illustration) apply a small
bead of adhesive around the outside edge.
Place the jewel into the drilled hole.
This Side fLAppearance
Agoa_lst _Side
_'_der t ...........
Jewel
STEP 7
REINSTALL ORIGINAL
HANDLE OR OPTIONAL
CUSTOM HANDLE
A custom handle (not supplied) mag be installed.
• Drill pilot holes through the front of the custom
panel and through the metal panel to match
the chosen handle.
NOTE:The handle screws should be installed through
the metal panel, the custom panel and into the custom
or original handle.
i STEP 8 INSTALL ASSEMBLED PANEL
TO THE DRAWER
• Install the custom panel assemblg to the exposed
drawer front using the original 7 screws.
/
CustomHandle
or Original Handle o
11