Aztech HL117 E User Manual page 19

User Manual
Step 2
Press Simple Connect for 5-8 seconds from a HomePlug AV Z. After you release the button, Power
LED and Ethernet LED (Ethernet is connected) will turn off and turn on.
Note: If the Power and Ethernet LED did not turn off and on, press Simple Connect again for 5-8
seconds.
Step 3
Press Simple Connect Button for two seconds on the existing HomePlug AV device. After you release
the button, the Power LED will continuously blink. If the Power LED did not blink, press
Simple Connect again for two seconds.
Make sure to press Simple Connect Button again on the HomePlug AV Z within two minutes after
you press Simple Connect from the existing network.
Page 19 of 43