MAINTENANCE WORK ON CHASSIS AND ENGINE
Checking gear oil level
9.89
Info
The gear oil level must be checked when the engine is cold.
Changing the gear oil
x
9.90
–
Drain the gear oil.
x
(
–
Fill up with gear oil.
(
x
Draining the gear oil
x
9.91
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
–
Wear suitable protective clothing and protective gloves. If you get scalded, immediately flush the affected areas with luke-
warm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the gear oil only when the engine is warm.
–
Place a cloth beneath the carburetor to soak up emerging fuel.
–
Remove plug
–
Completely drain the fuel.
–
Mount and tighten the plug.
700458-01
–
Stand the motorcycle upright on a horizontal surface.
–
Remove gear oil level check screw
–
Check the gear oil level.
A small amount of gear oil should flow out of the hole.
»
If no gear oil flows out:
–
–
Mount and tighten the gear oil level check screw.
Guideline
Screw, gear oil level check
300661-10
p. 55)
p. 56)
–
Stand the motorcycle on its side stand on a horizontal surface.
–
Place a suitable container under the engine.
–
Remove the gear oil drain plug with magnet
–
Completely drain the gear oil.
–
Thoroughly clean gear oil drain plug with magnet.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet and the seal ring and tighten it.
Guideline
Oil drain plug with magnet
300659-10
.
Add gear oil.
x
(
p. 56)
. Stand the vehicle upright.
M6
6 Nm (4.4 lbf ft)
.
M12x1.5
20 Nm
(14.8 lbf ft)
55