Bosch Carephone 61 User Manual page 18

18 en | Programming
11- 19 & 10 Destination number of the emergency call recipient
You can enter here the destination number of the emergency call recipient,
either a telephone number, or an IP address.
a. Enter the destination number of the emergency call recipient.
In the case of a telephone number, register the call number as follows:
You can add the following criteria in a telephone call number:
B = Dial pause, D = Dial tone detection.
In the case of an IP address, the call number should be written in numbers
without dots, always with 12 digits. Example: 192168010001.
b. Press C to confirm.
After entering the call number, you must enter the protocol:
– 0 = monitoring centre (protocols RB2000, RB2000E, ANT)
– 1 = monitoring centre (TTnew+ protocol)
– 3 = monitoring centre (CPC protocol)
– 4 = to phone with acknowledgement
– 5 = to phone without acknowledgement (only for direct call)
– 7 = monitoring centre (BS8521 protocol)
– 9 = monitoring centre (RBIP protocol)
The Carephone 61 goes automatically to the next programming step and
you can enter the next call number. When an emergency call is sent and if
the call to the first call number is not successful, the Carephone 61 will try
the next numbers in the sequence 11 to 10. If the last number has been
dialed unsuccessfully, the unit starts with the first number again and
continues until it either sends an emergency call successfully. A single
programmed number will be tried 12 times. For several numbers, a
maximum of 15 calls in total will be made.
F.01U.239.30x | V1 | 2011.06 User Manual
Carephone 61
Bosch Security Systems