KitchenAid KDRS505XSS00 Installation Instructions Manual page 21

2. Unscrew the hex-shaped regulator cap from the regulator and
remove the regulator pin.
A
\
\
B
3=
A. Regu_rp_
B. Regu_rcap
Flip the regulator pin over and snap pin firmly into place.
A
A. LP gas position
B. Natural gas position
4. Screw the hex-shaped regulator cap securely back into place.
Do not overtighten.
To Convert Surface Burners
1. If installed, remove the burner grates.
2. Remove the burner caps.
3. Using a Phillips T20 Torx®screwdriver, remove the burner
base.
4=
Apply masking tape to the end of a 9/32"(7.0 mm) nut driver to
help hold the LP gas orifice spud in the nut driver while
changing it. Press nut driver down onto the LP gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set the LP gas orifice spud aside.
A
A. LP gas orifice spud
Use the following chart for correct Natural gas orifice spud for
each burner. Refer to the model/serial rating plate behind the
control panel for proper sizing of Natural orifice spuds for each
burner location.
Natural Gas Orifice Spud Chart
Burner Rating Color Number
5,000 BTU Green 107N
7,300 BTU Yellow 125N
9,200 BTU Orange 142N
10,000 BTU Transparent 149N
15,000 BTU White 180N
16,000 BTU Black 195N
5. Replace the LP gas orifice spud with correct Natural gas
orifice spud. See the "Natural Gas Orifice Spud Chart."
6. Replace burner base and hand tighten the screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
9. Place LP gas orifice spuds in plastic parts bag for future use
and keep with literature package.
10. Replace burner grates.
11. Complete installation. See "Make Gas Connection" and
Electronic Ignition System" sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame W'
to V2" long. The outer cone is not as distinct as the inner cone.
Natural gas flames do not have yellow tips.
IMPORTANT: You may have to adjust the low setting for each
cooktop burner.
A. Burner cap
B. Gas tube opening
C. Burner base screws
D. Burner base
21