Using The 5235 Ip Phone With 5310 Ip Conference Unit; Access The Conference Controller; Turn The Conference Unit On And Off; Adjust The Conference Unit Volume - Mitel 5235 User Manual

5235 IP Phone SIP User and Administrator Guide
USING THE 5235 IP PHONE WITH
5310 IP CONFERENCE UNIT
The 5235 IP Phone uses the 5310 IP Conference Unit for conferencing. You use the
Conference Controller to turn the conference unit off or on, to adjust the volume or to put
the conference unit into Presentation mode. You can only run one Conference Controller
session at a time. If the 5310 Conference Unit is not connected to the 5235, the
Conference Controller application is not available.

Access the Conference Controller

To access the Conference Controller:
• Open the Application shutter and press the Conference Controller label, or
• Open the Phone shutter and press the key programmed to the Conference
Controller application.

Turn the conference unit on and off

1. Verify that the conference unit is connected to the 5235 IP Phone.
2. Access the Conference Controller. For more information, see Access Conference
Controller.
3. Press Turn On/Turn Off.
Note: Use the same Touch Screen button to turn your conference unit on and off. The
button presents the appropriate option depending on the state of your conference unit
(Turn Off when the unit has already been turned on, and vice versa).

Adjust the conference unit volume

• Press Volume Up or Volume Down.

Place the conference unit in Presentation mode

Presentation Mode is used when only one individual is speaking to a group. If another
member in the group wishes to speak, you must disable Presentation Mode. Presentation
Mode minimizes extraneous noise.
• Press Presentation Mode.

Exit the conference controller

• Press Close.

Mute the conference unit

To mute the conference unit so that conversation in the meeting room cannot be heard
by individuals being conferenced:
• Press Mute.
- 36 -