Wavetek MS1000 Operation Manual page 20

You must enable a channel in order to perform measurements on it.
A check mark appears in the left-hand column when the channel is
enabled. When you built the plan, microStealth automatically
enabled all the channels it found to be active on your system. You
may want to verify that all your channels have been correctly
enabled. Use the
highlighted in the list.
There are several parameters that you can specify for each channel.
To do this, highlight the desired channel using the up or down
arrow and press the
for that channel appear.
Use the up or down arrow to highlight the desired parameter. Press
the key to edit the selected parameter. After completing your
entry, be sure to press the
Enabled
As mentioned earlier, a channel must be enabled in order
for it to be measured. This is another place where you can
enable or disable the channel.
20
soft key to enable/disable the channel
soft key or the
key again.
key. The parameters