MAINTENANCE
REPLACING THE LARGE BELT (See Figures 14-16)
• Remove the 4 screws that secure the left side plate to the frame of the Snow Thrower (Fig.
14). Remove the side plate.
• Pull the bearing away from the small pulley. Remove the belt from the large pulley and the
small pulley that is located inside the housing (Fig. 15).
• Position the new belt over the small pulley (Fig. 16).
• Rotate the rotor with the left hand while positioning the belt on the large pulley with the right
hand (Fig. 16).
• Install the left side cover, and secure it using the 4 screws.
Left side cover
Large pulley
STORAGE
• Run the Snow Thrower for a few minutes in order to melt any snow that may be left on the
Snow Thrower.
• Disconnect the extension cord from the Snow Thrower.
• Inspect the extension cord thoroughly for signs of wear or damage. Replace it if it is worn or damaged.
• Inspect the Snow Thrower thoroughly for worn, loose, or damaged parts. If any parts must be
repaired or replaced, contact the Toll-Free Helpline, at 1-888-909-6757.
• Store the extension cord with the Snow Thrower.
• Store the Snow Thrower in a clean, dry place. Cover it in order to provide added protection.
Fig. 14
Screw
Bearing
Large pulley
20
Fig. 15
Belt
Bearing
Small
pulley
Belt
Fig. 16
Small
pulley