Advertisement
Available languages
Available languages
LEVEL
WASHESR_R
IMPORTANT:
Level washer/dryer
properly to reduce excess
noise and vibration.
i,
Check levelness
of washer/dryer
-
With washer/dryer
in its final location,
place a level on top
edges
of washer/dryer.
Use side seam as a guide to check
levelness of sides. Check levelness of front using lid, as
shown. Rock washer/dryer
back and forth to make sure all
four feet make solid contact with floor. If washer/dryer
is level,
skip to step 2.
Not Level
LEVEL
Not Level
Adjust leveling
feet
If washer/dryer is not level, use a 9/16" or 14 mm open-end or
adjustable wrench to turn jam nuts clockwise on feet until they
are about 1/2" (13 mm) from the washer/dryer cabinet. Then
turn the leveling foot clockwise to lower the washer/dryer or
counterclockwise
to raise the washer/dryer. Recheck levelness
of washer/dryer and repeat as needed.
HELPFUL TIP: You may want to prop up front of washer/dryer
about 4" (102 mm) with a wood block or similar object that
will support weight of washer/dryer.
Tighten
leveling
feet
When washer/dryer
is level, use a 9/16" or 14 mm open-end
or adjustable wrench to turn jam nuts counterclockwise
on
leveling feet tightly against washer/dryer
cabinet.
HELPFUL TIP: You may want to prop washer/dryer
with
a wooden block.
in U.S.A.
Electrical Shock Hazard
Plug into a grounded 3 or 4 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow
these instructions can result in death,
fire, or electrical
shock.
Plug into a grounded
3= or 4= prong
outlet
23
Advertisement
