Permobil M400 Owner's Manual page 106

Owner´s Manual Permobil M400
Trouble Shooting Guide
The troubleshooting guide below describes a number of events that can arise
when you use your wheelchair, as well as providing suggestions for solutions.
Note that this guide does not describe all the possible events that can arise,
and you should always get in touch with your service contact or Permobil when
you are unsure
EVENT
The wheelchair does not start. Batteries discharged.
The wheelchair can not
be driven.
The wheelchair stops while
being driven.
The wheelchair can only
be driven with reduced speed. lowest position.
Applies for electrical seat
lift only.
The wheelchair will
not charge.
POSSIBLE CAUSE
The cable connection to the
control panel has become
loose.
Circuit Breaker set in "OFF"
position after, for example,
changing batteries.
Triggered Circuit Breaker.
Battery charger connected.
wheel locks activated.
The wheelchair is locked.
The cable connection to the
control panel has become
loose.
Triggered Circuit Breaker.
seat lift raised from its
Circuit Breaker set in "OFF"
position after, for example,
changing batteries.
108
Troubleshooting Guide
SOLUTION
Charge the batteries.
atttach the cable to the control
panel.
reset the Circuit Breaker.
see page 98.
see page. 98.
Terminate the charging and
remove the charging cable
from the charging outlet.
reset the wheel locks.
unlock the wheelchair. see
page 36.(Vr2) alt. 68.(r-net)
atttach the cable to the control
panel.
See page 98.
lower the seat lift.
reset the Circuit Breaker.
see page 98.