Whirlpool YSF315PEGQ6 Installation Instructions Manual page 9

Gas and electrical connections
All connections must be wrench-tightened.
Typicalrigidpipeconnection
__ pressure
regulator 90Oelbow
90°elb°w . I I _ blackiron
nipple union _--pipe
union-- _ manual
gas shut-
nipple --_ff valve
1/2" t o3/4"
gas pipe --L_
Typicalflexible connection
pressure
-- regulator
90°elb°w adalpter_ '2::ibol: c°n"
L_ use pipe-joint
compound
adapter -- E_
manual
gas shut-
t-- Off valve
1/2" t .o 3/4" q'L/
gas pipe
A 1/2" male pipe thread is needed for connection to
pressure regulator female pipe threads,
[]Apply pipe-joint compound made for use with L. R
gas to the smaller thread ends of the flexible connector
adapters. Attach one adapter to the pressure regulator
elbow and the other adapter to the gas shutoff valve.
Tighten both adapters.
O[] Use 15/16" combination wrench and channel
lock pliers to attach the flexible connector to the adapters.
Check that connector is not kinked.
/
regulator shutoff valve
in "on" position
to range
gas supply
" Check that range regulator shutoff valve is in the
"on" position. Open the manual shutoff valve in the gas
supply line.
,, Use a brush and liquid detergent to test all gas
connections. Bubbles around connections will indicate a
leak. If a leak appears, shut off gas valve controls and
tighten connections.Then check connections again.
Never test for gas leaks with a match or other flame,
Clean all detergent from range.
[]Center the burner cap on burner base.
Burner cap should be level when properly positioned.
Place burner grates over burner.
[] Plug power supply cord into grounded
electrical outlet.
Page 9