Check Operation - Whirlpool YSF315PEGQ6 Installation Instructions Manual

Check operation
Electronic ignition system
Cooktop and oven burners use electronic ignitors in place
of standing pilots. When a cooktop control knob is turned
to the "LIGHT" position, the system creates a spark to
light the burner.This sparking continues until the control
knob is turned to the desired setting.
When the oven control is turned to the desired setting, a
hot surface ignitor heats to a bright orange and ignites the
gas. No sparking occurs and the glow bar remains on
while the burner operates.
Check operation of cooktop
Check operation of oven burner
,, Open broiler drawer. Follow the instructions for
your type of oven controls.
mPush in and turn each surface unit control
knob to "LIGHT" position.The flame should light within
4 seconds.Turn control knob to "HIGH" position after
burner lights.
Check each cooktop burner for proper flame.
The small inner cone should have a very
distinct blue flame 1/4" (6 mm) to 1/2" (13 mm)
long.The outer cone is not as distinct as the
inner
cone.
B
1. Press the "BAKE" pad.
•The "BAKE" indicator will light.
• "350" will appear in the display.
2. Press the START/ENTERpad.
•The "PREHEAT" or "HEAT," and "ON" indicators will
appear.
,The oven burner should light in 50-60 seconds; this
delay is normal. The oven valve requires a certain
time before it will open and allow gas to flow.
= Push in and turn each cooktop control knob
from "LIGHT" to "LOW" setting quickly.The low flame
should be a minimum, steady blue flame. If flame needs
to be adjusted, turn control knob to the "LOW" setting
and remove control knob. Insert a small flat-blade
screwdriver into the valve stem. Turn the valve screw to
obtain the smallest flame that will not go out when the
control of a cold burner is quickly turned from "HIGH" to
"LOW': Repeat for other cooktop burners as needed.
lira Q am
C
1.Press the "BAKE" pad.
•The "BAKE" indicator will light.
•"350F" will appear in the display.
2. Press the START/ENTERpad.
, "PrE" and "10:00" will appear in the display.
, "HEAT" and "ON" indicators will light.
Page 10