Table of Contents
Advertisement
Check operation
(cont.)
A
TIMER
BAKE
--
o
I
BROIL--®
II
START
? --
®
HEAT --O
II
CLEA_
--
e/
DOOR
LOCKED
ON
I
@
B
1. Press the "CUSTOM BROIL" pad.
• "525" or "HI" will appear in the display.
• The "BROIL" indicator will light.
2. Press the "START/ENTER" pad.
• "HEAT"(console B only) and "ON" indicators
will light.
• The oven burner should light in 50-60
seconds;this delay is normal. The oven
valve requires a certain time before it will
open and allow gas to flow.
umm
% i1lm
D
1. Press the "CUSTOM BROIL" pad.
, "HI" will appear in the display.
, The "BROIL" indicator will light.
2. Press the "START/ENTER" pad.
• "HEAT"and "ON" indicators will light.
• The oven burner should light in 50-60
seconds; this delay is normal. The oven
valve requires a certain time before it will
open and allow gas to flow.
mCheck the broil burner for proper
flame. The flame should be 1/2" long, with
inner cone of bluish-green, and outer
mantle of dark blue, and should be clean
and soft in character. No yellow tips,
blowing or lifting of flame should occur.
If flame needs to be adjusted:
Loosen the lock screw on the air shutter
located at the rear of the broil burner.
Adjust the air shutter as needed.
Tighten lock screw.
m [] Turn the oven control knob to "OFF"
or press the "OFF/CANCEL" pad.
You have just finished installing
your new range. To get the most
efficient use from your range, read your
Use & Care Guide.
Keep Installation Instructions
and Guide
close to range for easy reference.
The instructions will make installing the
range in another home as easy as the
first installation.
Gas conversions (from Natural gas to LP. gas; or
from LP. gas to Natural gas) must be done by a
qualified installer.
Fire Hazard
Shut off gas supply
line valve.
Make all conversions
before turning
gas
supply valve back on.
Failure to follow these instructions could
result in explosion, fire or other injury.
L.R gas conversion
[] Complete installation sections A-C (Pages
4-5) before converting cooktop to L.P. gas. Check
that main gas supply line has been shut off and
the power supply cord is disconnected.
screws
[] Remove storage drawer and oven racks.
Remove burner grates, caps and screws holding
burner bases to cooktop. Lift burners off cooktop.
pressure
regulator
\
--cap
--washer
--
Nat, gas
LP. gas
DO NOT REMOVE THE PRESSURE REGULATOR.
[] Pressure regulator: Remove plastic cover.
Turn cap marked "N" on front of pressure
regulator counterclockwise with a wrench to
remove. Do Not disturb or remove the spring
beneath the cap. Turn the cap over and reinstall
cap on regulator so that the letters "LP." are
visible. Replace plastic cover over cap.
Page 7
Advertisement
Table of Contents
