Table of Contents
Advertisement
Screening Your Calls
You can use the answering system for call screening. While the system
takes a message, you can listen on the base speaker (if you turn on Call
Screen) or from a handset. Only one handset can screen calls at a time. If
another handset tries to screen calls, it beeps and returns to standby.
To...
hear the caller leaving
a message
answer the call
mute the call screen
without answering*
* If you mute the call screen, the system continues taking the message: it just
stops playing through the speaker.
Using the System While You're Away from Home
You can dial in to your answering system from any touch-tone phone.
Before you can use this feature, you must program a security code.
Programming a Security Code
With the phone in standby, open the menu; select Answering
Code. Use the number keypad to enter a two-digit security
select Security
code (01 to 99). Press
#
Remember to make a note of your new security code!
Dialing In to Your System
1. Call your phone number and then wait for the system to answer. (If
turned off, it answers after 10 rings and sounds a series of beeps.)
2. During the greeting or beeps, press
security code. If you enter it incorrectly 3
times, the system hangs up and returns to
standby.
3. The system announces the time, number of
messages in memory, and a help prompt. It
beeps to indicate it's waiting for a command.
4. When you hear beeping, enter a 2-digit
command from the chart. Each key must be
pressed within 2 seconds of each other or
the entry will be timed out.
English - 20
From the base
Listen to the caller
over the speaker.
Press
sPEakEr
Press
Play/sToP
when you're finished.
MEnu/sElEcT
From a handset
Press
.
Press
Press
.
handset to the cradle.
0 and immediately enter your
01 Repeat message
02 Play message
03 Skip message
04 Delete message
05 Stop playback
06 Turn the system on
09 Turn the system off
10 Hear help prompts
.
MEssagE/MuTE
.
Talk/Flash
or return the
End
Setup, then
Advertisement
Table of Contents
