Using Special Features; Silent Mode; Multihandset Features - Uniden D1785 Series User Manual

answering system answers any incoming calls without playing anything
through the speaker.
1. With the phone in standby, press and hold
on the base for one second. The phone prompts you to select the
sIlEnT
number of hours (1 - 9 or Always
mode.
2. Select the number of hours using the up or down key.
3. To confirm, press
can also just wait about 5 seconds. The phone turns on the answering
system and displays Silent Mode
4. After the selected number of hours, the phone automatically exits silent
mode. To exit silent mode manually, press and hold
handset or
sIlEnT
#
If you do not make an entry, after 5 seconds the phone goes into
Standby mode without the confirmation tone but will turn on

Silent mode.

#
If the phone is in silent mode and you turn off the answering
system, the phone exits silent mode

Multihandset Features

#
To use the features in this section, you need at least 2 cordless
handsets and 1 cordless handset for accessory handset.
• Your base supports a total of 12 cordless accessory handsets, including
any that came with your phone.
• You must register accessory handsets to the base before using them.
(Handsets that came packaged with the base are already registered.)
• Handsets that aren't registered display a Not Registered message. For
registration instructions, see page 23 or see the accessory handset manual.
• If a handset was ever registered to a base, you must reset it before it can
register to a new base; see page 22, or see the accessory handset manual.
Conference Calling
• When an outside call comes in, two cordless handsets and the base can
join in a conference call with the outside caller.
• To join a call that's already in progress, just press
handset or
sPEakEr
• To leave the conference call, hang up normally; the other stations
remain connected to the call.
English - 14
On) that you want it to stay in silent
on any handset or
#/sIlEnT
On.
on the base again.
on the base.
on any handset or
#sIlEnT
on the base. You
sIlEnT
#/sIlEnT
on the
Talk/Flash
on any