Recalling The Factory Settings Of General Crescendo - Johannus Rembrandt 200 User Manual

Recalling the factory settings of general crescendo

The factory setting of stop combinations in the general crescendo can be restored as follows.
1. Make the memory accessible by turning the MEMORY LOCK a quarter turn to the right. The
SET piston will light up to indicate the memory can be accessed.
2. Push the pistons GC and PGM. The display will show a 0 (level 0, meaning all stops of the
general crescendo off).
Also all stops will switch off. Changing the general crescendo pedal will have no effect
anymore.
3. Push one of the 0 pistons (keep on pushing) and push the SET then.As long as you push the
SET piston a P will show up in the display to indicate that the personal registration is
programmed into the general crescendo memory.
4. Release the SET piston before releasing the 0 piston.
5. Close the general crescendo memory by turning the key switch MEMORY LOCK a quarter
turn to the left and eventually remove the key from the switch. The light in the SET piston will
go off to indicate that the memory is not accessible anymore.
6. Push the PGM piston again to switch it off. The general crescendo can be used as normal
again.
User's Manual
M e m : 1 V o l : 1 2
T r a n s : 0 C r e s c e n d o :
M e m : P 6 V o l : 1 2
T r a n s : 0 C r e s c e n d o :
JOHANNUS JOHANNUS
27
T u n e : 4 4 0
0
T u n e : 4 4 0
0
Rembrandt 200, 300, 2000 and 3000 AGO