Dyna-Glo RMC-KFA50DGD User's Manual And Operating Instructions page 6

NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
2. ASSEMBLY
For RMC-KFA50DGD/75TDGD Models only
(Assembly time for this product is 3 minutes)
Tools Required
• Medium Phillips Screwdriver.
1) Lift front guard for arrow direction and make
sure that guard's wedged portion fits into the slit
hole on the upper housing.
2) Align the holes in the upper housing with two
mounting holes on the handle as shown in Figure 6.
3) Secure handle with Screws with provided.
For RMC-KFA125/170/210TDGD-01 Models only (Assembly time for this product is 10 minutes)
Tools Required
• 3/4 inch Socket or Adjustable Wrench
1) Align and insert snapfit front leg in to the front section of the bottom leg and wheel support. You will need
to depress the metal buttons when installing. See Figure 7 below.
2) Slide threaded axle through the rear sectioon of the bottom leg and wheel support.
3) Slide one axle bushing on to each side of the axle. Slide one wheel on to each side of the axle. Attach one
cap nut on to each side of the threaded axle and tighten well.
4) Align and insert snapfit front and rear handles to the top support handle. You will need to depress the metal
buttons on each handle when installing. See Figure 7 below.
Button
Hole
Top Handle Support
Snap Fit Front Leg
Bottom Leg And Wheel Support
CAUTION : DO NOT OPERATE heater without support frame assembled to tank.
NOTE : Heater should be inspected before each use, and at least annually by a qualified service person.
Wheel
Cap Nut
Figure 7. Assembling Handles & Wheels
Handle
Figure 6. Assembling Handle
Snap Fit Front Handle
Snap Fit Rear Handle
5
Screw
Front Guard
Wedged Portion
Slit Hole
Threaded Axle
Bushing