Download Print this page

Dehumidifier Feature - Kenmore 253.25031 Use And Care Manual

Kenmore dehumidifier
Hide thumbs


Dehumidifier Feature

Allow the unit to reach room temperature before operating.
To begin operating the dehumidifier, follow these steps:
NOTE: Unit must be upright for one hour prior to operating.
1. Plug the power cord into a properly grounded 115 volt AC outlet.
NOTE: If the "BUCKET FULL" light is on, remove the bucket and reinstall it to reset the float switch.
2. To turn the unit on, press the ON/OFF button. The unit will run in the factory setting of CONTINUOUS and high
fan speed. In the Continuous Mode the unit will only display CO and not the room humidity. It is recommended
you leave the unit running in the CONTINUOUS setting for the first three or four days until the sweating and
dampness odors have stopped.
3. After a few days, when the Relative Humidity has declined, press the HUMIDITY
value between 35% to 85%, so the room is kept at a comfortable concentration. Pressing the
will change the humidity selection in 5% increments. After you have set the desired humidity, the readout will
display the actual room humidity. If at any time you want to return to the CONTINUOUS Mode, pressing the
button will lower the Relative Humidity through the 5% increments until the display reads CO.
buttons to choose a

Hide quick links:



This manual is also suitable for: