Troubleshooting Guide - Kenmore 253.25031 Use And Care Manual

Kenmore dehumidifier
Table of Contents

Advertisement

Dehumidifier Troubleshooting Guide
DEHUMIDIFIER DOES NOT OPERATE.
Check if
Wall plug disconnected.
House fuse blown or circuit breaker tripped.
The dryness level you selected has been reached.
Bucket not installed properly.
Water in the bucket has reached its preset level.
Dehumidifier is not turned on.
"BUCKET FULL" light is on.
DEHUMIDIFIER RUNS TOO MUCH.
DEHUMIDIFIER IS OPERATING BUT ROOM IS NOT DRY ENOUGH.
Dehumidifier runs too much.
FROST APPEARS ON COILS ABOVE BUCKET OR DRIP TRAY.
FAN NOISE.
Then
Push plug firmly into wall outlet.
Replace fuse with time delay type or reset circuit breaker.
Dehumidifier automatically shuts off when selected amount of moisture has been
removed from the air. If you want to remove more moisture, select
'CONTINUOUS' by using the humidity button or knob. After the dehumidifier
starts, reset the control to the desired setting.
Reinstall the bucket properly. See "Removing Collected Water" for reference.
Empty bucket and return bucket to position.
Turn unit on.
Remove bucket, empty water and reinstall it correctly.
Refer to some of the causes under DEHUMlDIFIER RUNS TOO MUCH.
10

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

253.25033253.25032

Table of Contents