Cut Position - Paxar 610 User Manual

♦ If the data is too close to the left side, increase the number.
♦ If the data is too close to the right side, decrease the number.
To change the setting, from the Main Menu, select Setup, then Supply, then Positioning.
Then, follow these steps.
1. Press or
2. Press Enter / Pause. You will see the current setting, for example:
3. Press or
(moves the image toward the left side of the supply);
toward the right side of the supply).
4. Press Enter/Pause when the number you need appears. Press Escape / Clear twice
to exit to the Main menu.

Cut Position

This function adjusts where the tag is cut. The printer adjusts the cut position according to
the black marks on the supply. You may need to adjust for aperture supplies. Increase to
move the cut up; decrease to move the cut down.
To change the setting, from the Main Menu, select Setup, then Supply, then Positioning.
Then, follow these steps.
1. Press or
34 • 3. Setting Supply Options
__________
Changing this setting only affects
new formats sent to the printer.
__________
until you see
Enter margin pos
[-99/99]: +0
to change the margin position. Pressing
until you see
Positioning
Margin Pos
Positioning
Cut Pos
decreases the value
increases it (moves the image
Users Manual - 610 / 611 / 612 Printers