Washing Sequence - Haier HWM108VA User Manual

Ï ´ µ Ó Ë ³ Ð ò

Washing sequence

Wash selector
Wash timer
(Strong current,
(To set to below 2 minutes,
Standard current)
first set to 6 minutes then
turn it back.).
STRONG
STANDARD
Wash
1.Water-filling selector
1 Set the water inlet selector at the "WASH" side.
(Figure 1)
2 Set the water level adjusting lever to needed line.
2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
Page7 Page7
3.Put in the laundries. If the water quantity is
insufficient, please add water.
4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the laundries.
(Figure 4)
Remarks:
1. 0~15 minute is the normal washing.
2. 15~45 minute is active soaking. During active soaking, the pulsator
will run for 2 minutes in each 8 minutes. After the active soaking, it
will run normal washing for 15 minutes.
3. If you select soaking(i.e. turn the knob to position between 15~45
minutes), be sure to dissolve the washing powder in advance,
otherwise the washing powder may result in
damage to the laundries.
6.After washing, set the "WASH SELECTOR"
at "DRAIN". (Figure 5).
Drain selector Spin timer
Not set the switch to (To set to below 1 minute,
first set to 2 minutes then
DRAIN during washing
turn it back. it can increase
the service life of the timer).
5 5
DRAIN DRAIN
4 4
3 3
WASH SPIN
WATER INLET SELECTOR
Figure 1
Figure 2
STRONG
STANDARD
Figure 3
Figure 4
DRAIN DRAIN
Figure 5
8
Midway spinning
1 1
1.Put the laundries into the spin tub evenly and smoothly.
2.Spin
2 2
(1) Put the gland in properly.
Please put in the gland properly even if the laundries quantity is small.
(2) Close the inner and outer cover of the spin tub.
(3) Spin for 1-2 minutes.
3.Run the foam-removing spinning.
Push
Gland
Push
Proper The laundries Proper
are slanting
Outer cover of
the spin tub
Inner cover of
the spin tub
1 Set the inlet selector handle on spin side and
fill water for about 1 min.
In case water flows out from wash tub side
due to too much inflow, please turn down
the water tap a bit.
2 Close the spin tub outer cover and spin
for about 1 - 2 min.
9
No gland
WASH SPIN
WATER INLET SELECTOR