Cleaning The Lint Filter - Haier HWM108VA User Manual

Semi auto washing machine
Hide thumbs Also See for HWM108VA:
Table of Contents

Advertisement

Maintenance
Ï ´ º ó ´ ¦ À í
After using, please clean the lint and foreign materials of the lint filter and
overflow filter in time. Otherwise it may influence your using the machine.
Please first pull off the power plug from the receptacle before cleaning.

Cleaning the lint filter

The lint filter must be used during washing.
It must be cleaned in time after each using.
Lint filter:
1.Push down the spring piece of the top lint filter to
make the claws out of the filter cover, and then
pull out the lint filter to get it down. figure1
2.Pull the back of the lint filter, and then you can get
down it off the front cover of the lint filter. figure2
3.Sweep the rubbish in the lint filter.
4.Put the back of the lint filter into the front cover .
5.Put the lint filter into filter cover, and make it tight .
6.Make sure the lint filter well installed, or it can
influence your use.
12
Up
Install
Dismantle
Down
Figure 1
Lint filter rear cover
Disassemble
Install
Lint filter front cover
Figure 2
How to change the direction of the drain hoses
Figure 1 indicates the ex factory installation
position of the drain hose.
Extend the drain hose from the side of spin tub
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Dismantle the drain hose fixing clamp and take
the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the side
of the spin tub in the order of 1 ~ 3 , heading for the
side of the spin tub. (See to Figure 3).
Embed the drain hose into the groove with
hands. Take care not to damage the drain
hose in fastening the fixing clamp.
Install the water inlet hose; Select the water level
Insert the water inlet hose into the water-filling
entrance on the control panel
To
dismantle the water inlet pipe, just push the
control handle as indicated in the figure and
pull it out
Select water level according to the
quantity of the laundries.
Set the water level adjusting lever
to needed line.
Use the new water inlet hose provided
with the machine to connect to the
water faucet.Old hose sets should
not be reused.
Back
Front
Figure 1
Soft item
Figure 2
Extend to the
spin tub side
Fig ure 3
Water inlet
hose
Water-filling
entrance
Water level
indicator
Max
Maximum
Med
Medium
Min
Minimum
5

Advertisement

Table of Contents
loading

Table of Contents