Advertisement
Table of Contents
- 1 Table of Contents
- 2 Introduction / System Features
- 3 System Features
- 4 Guided Tour - CR277 Front Panel
- 5 Guided Tour - CR277 Rear Panel
- 6 Guided Tour - HT7
- 7 Setting up and Using the Concert Series System
- 8 Setting up and Using the Concert Series System
- 9 Specifications
- 10 Concert Series Frequency Conversion Chart
- Download this manual
Advertisement
Table of Contents
Related Manuals for Samson Conert 277
Summary of Contents for Samson Conert 277
- Page 3 Copyright 2009, Samson Technologies Corp. Printed, January 2009 v1 Samson Technologies Corp. 45 Gilpin Avenue Hauppauge, New York 11788-8816 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 631-784-2201 www.samsontech.com...
-
Page 4: Table Of Contents
Table of Contents Introduction / System Features......1 System Features ........2 Guided Tour - CR277 Front Panel. -
Page 5: Introduction / System Features
(that is, the same radio frequency) in order to operate correctly. The Samson Concert Series system you have purchased operates in the HDTV free UHF frequency range and contains a CR277 dual channel receiver and two of our HT7 hand- held microphone transmitters with the Samson Q7 dynamic capsule. -
Page 6: System Features
System Features Designed for use in both live sound and sound contracting applications, the Samson Concert Series Wireless System provides a high performance, cost effective solution, utilizing state-of-the-art technology in wireless communications. Main features include: • Six different available channels in three pairs, all operating in the less crowded UHF bandwidth, and all designed for simultaneous use. -
Page 7: Guided Tour - Cr277 Front Panel
Guided Tour - CR277 Front Panel 1: Antennas (Channels A and B) - The antenna mountings allow full rotation for optimum placement. In normal operation, both Antenna A (the antenna on the left) and Antenna B (the antenna on the right) should be placed in a vertical position. Both antennas can be folded inward for convenience when transporting the CR277. -
Page 8: Guided Tour - Cr277 Rear Panel
Guided Tour - CR277 Rear Panel CR277 1: MIX OUT switch - Sets the OUTPUT B balanced output to send either the combined signal for Channel A and B when the switch is in the "ON" position, or to just Channel B when in the "OFF" position. -
Page 9: Guided Tour - Ht7
Guided Tour - HT7 1: Audio on-off switch - When set to the “on” position, audio signal is transmitted. When set to the “off” position, the audio signal is muted. Because the carrier signal remains during muting, no “pop” or “thud” will be heard. -
Page 10: Setting Up And Using The Concert Series System
“line of sight” between the receiver and transmitter so that the person using the transmitter can see the receiver). An optional rack-mount kit (available from your Samson dealer) allows the CR277 to be mounted in a standard 19" rack if desired. Extend both “A” and “B”... - Page 11 Setting Up and Using the Concert Series System 8. Turn on the power to one of the HT7 transmitter (using its Power on-off switch); the green “HIGH” Battery strength LED will light if the battery is sufficiently strong. At this point, a few segments in the CR277 front panel RF Level meter should light;...
-
Page 12: Setting Up And Using The Concert Series System
If you have followed all the steps above and are experiencing difficulties, contact your local dis- tributor or, if purchased in the United States, call Samson Technical Support (1-800-372-6766) between 9 AM and 5 PM EST. -
Page 13: Specifications
Specifications System Specifications Channels N:6, U:6, E:4, B:4 Frequency Type Modulation Type Noise Reduction Type Compander/Expander Distance 300 feet Transmitter (HT7) Oscillation Type Direct PLL Pre-emphasis 50 µsec Antenna Integral Antenna Maximum Input Level 3 V p-p Battery Type Duracell MN1604 9-volt alkaline Operating Temperature -20°... -
Page 14: Concert Series Frequency Conversion Chart
Concert Series Frequency Conversion Chart... - Page 15 FCC Rules and Regulations Samson wireless receivers are certified under FCC Rules part 15 and transmitters are certified under FCC Rules part 74. Licensing of Samson equipment is the user’s responsibility and licensability depends on the user’s classification, appli- cation and frequency selected.
- Page 16 Samson Technologies Corp. 45 Gilpin Avenue Hauppauge, New York 11788-8816 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 631-784-2201 www.samsontech.com...