Advertisement
Quick Links
Advertisement
Related Manuals for Samson XPDm
Summary of Contents for Samson XPDm
- Page 1 XPDm Digital Wireless System Owner’s Manual...
-
Page 2: Important Safety Information
By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. Copyright 2020, Samson Technologies Corp. v1.1 Samson Technologies Corp. 278-B Duffy Ave Hicksville, NY 11801 www.samsontech.com... - Page 3 Owner’s Manual Important Safety Information Read these instructions. 13. Unplug the apparatus during lightning storms, or when unused for long periods Keep these instructions. of time. Heed all warnings. 14. Refer all servicing to qualified personnel. Follow all instructions. Service is required when the apparatus Do not use this apparatus near water.
- Page 4 (RF) energy set by the Federal Communications Commission of the U.S. Gov- ernment. Hereby, Samson Technologies Corp., declares that this XPDm Digital Wireless System is in com- pliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
- Page 5 RA number prior to shipping your unit. Please retain the original packing materials and, if possible, return the unit in its original carton. If your XPDm Digital Wireless System was purchased outside of the United States, contact your local distributor for warranty details...
- Page 6 XPDm Digital Wireless RXD1M Receiver Features VOLUME/Power Control - This rotary knob controls the level of the receiver output and powers the RXD1m on and off. Turn clockwise to power on and counterclockwise to power off. The light ring around the VOLUME/Power Control will illuminate white when powered on.
- Page 7 Owner’s Manual RXD1m Receiver Features Rear Panel DC Input - Connect the suplied adapter here. WARNING: Do not substitute any other kind of power adapter. Doing so can cause severe damage to your RXD1m and void your warranty. Unbalanced Outputs - Use these unbalanced 1/4” and 1/8” jacks when connecting the RXD1m to consumer (-10 dBV) audio equipment.
- Page 8 XPDm system and so we recommend that this not be adjusted manually. If necessary, however, you can use the supplied screwdriver to raise or lower the input level.
- Page 9 Owner’s Manual PXD1 Beltpack Transmitter Callouts Input Connector - Connect the input device via this mini-XLR input jack. The PXD1 is supplied with either a lavalier or headset microphone that is wired to a P3 connector. Status Indicator - This LED displays the operation mode.
-
Page 10: Quick Start
XPDm Digital Wireless Quickstart In order for the XPDm Digital Wireless System to work correctly, both the RXD1m receiver and HXD1 handheld or PXD1 beltpack transmitter must be paired together. (NOTE: The XPDm Digital Wireless System will come paired from the factory). - Page 11 Speak or sing into the microphone at a normal performance level while turning up the PA system’s volume control until you reach the desired output level. NOTE: Only two XPDm systems can be used within close proximity to each other.
-
Page 12: Troubleshooting
XPDm Digital Wireless Troubleshooting Issue Solutions Make sure that the transmitter and receiver are both powered on. Ensure the transmitter’s batteries are installed correctly. Check that the transmitter is not muted. Confirm that the RXD1m adapter is correctly connected and plugged into an electrical outlet. -
Page 13: Specifications
Owner’s Manual Specifications System Working Range 100’ (30m) line of sight Audio Frequency Response 20Hz - 16kHz (+0/-3dB) T.H.D. (Overall) <0.6% (@AF 440Hz, +4 dBu) Modulation Type GFSK Signal to Noise >85dB,re 0dBu,20Hz-16kHz BW Operating Temperature –10°C (14°F) to +60°C (+140°F) Working Frequency 2.404~2.476 GHz RXD1m Receiver... - Page 14 Samson Technologies Corp. 278-B Duffy Ave Hicksville, New York 11801 Phone: 1-800-3-SAMSON (1-800-372-6766) www.samsontech.com...