Installing Accessories; Filter.lid; Mood.lighting; Safety.hardcover.locks - Hydropool Serenity Hot Tubs Owner's Manual

When unpacking your new Hydropool hot tub, you will find
an accessories bag inside containing
• pillows
• filter cover
• coloured light lenses (not required for units ordered with
optional L.E.D. lighting)
• tool for opening the wall fitting to access the light bulb
(not required for units ordered with optional fiber-optic
lighting)
• #10 expansion plug
• keys for equipment access door (for units ordered with
the cabinet)
• hose bib adapter (Europe only)
FILTER/ICE-bUCKET LIDS
The filter and ice-bucket
covers provided match the finish
of your Hydropool hot tub. As the
covers are identical to each other,
simply place over either opening
for a finished appearance.
MOOD LIGHTING
STANDARD MOOD LIGHTING
Press the 'light' pad on the topside control to turn the light
on and off.
LED MOOD LIGHTING
OPTIONAL - FACTORY INSTALLED
(INCLUDING GARDEN FX & HYbRID
FEFX LED/FIbER-OPTIC SYSTEMS)
Press the 'light' pad on the topside control to start the
following LED lighting modes. Pressing the 'light' pad
on/off within 3 seconds cycles through the various 'light
shows' . When the LED lighting is turned off for more than
5 seconds, then turned back on, the system will resume the
last 'light show' .
Description of Light Shows:
• Mode 1 – Synchronous colour change
• Mode 2 – Freeze mode, freezes on selected colour blend
from above mode (gives unlimited colour
blend selection)
• Mode 3 – solid colour blue
• Mode 4 – solid colour green
• Mode 5 – solid colour red
H y d r O p O O l I n d u s t r I e s

InstAllInG ACCessOrIes

CHANGING bULbS & LENSES
The coloured light lenses supplied with your hot tub (not
required for units with optional LED lighting) simply push
over the existing clear light lens.
SAFETY HARDCOvER LOCKS
The safety hard cover is designed to open away from the
control area, however, if the hot tub is symmetrical in
dimension, the cover can be oriented to open in either
direction. Simply place the cover on the hot tub, pull the
straps down so that they are fully extended, then release
slightly so that there is approximately 6 mm (1/4 in.) of
slack. Mark the position on the cabinet, and fasten the
receiver clip with the screws provided. Always ensure the
safety hard cover is in place and locked whenever the hot
tub is not being used.
OPTIONAL COvER REMOvER
Hydropool offers several different devices to assist in
the removal of the safety hard cover. Please refer to the
instructions supplied with your particular cover remover
for installation. For further information, contact your local
Hydropool dealer.
13