Step 8 Position Dishwasherunder Countertop; Step 9 Level Dishwasher - Danby DDW2405W Installation Instructions Manual

INSTALLATION INSTRUCTIONS
STEP 8 POSITION DISHWASHERUNDER COUNTERTOP
• Check to be sure that wires are secure under the
dishwasher and not pinched or in contact with
door springs or other dishwasher components.
TIP: Check tub insulation blanket.
It should be positioned so it is not bunched up or
interfering with door springs. Check by opening
and closing door.
• Push dishwasher into cabinet. The front corners
of the dishwasher door should be flush with
cabinet doors. Be careful not to dent front panel
with knees or damage countertop or cabinets
with dishwasher parts.
Do Not Push Against_
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.
Figure 15
Reposition Dishwasher
_'_/ , \ by Grasping Both
Wi_ Hands
STEP 9 LEVEL DISHWASHER
IMPORTANT
- Dishwasher must be
level for proper dish rack operation and
wash performance.
• Place level on door
and rack track inside
the tub as shown to
check that the dish-
washer is level.
Figure 16
• Level the
dishwasher by
adjusting the four
leveling legs
individually.
Turn
to Adj
Figure 17
Check
Level
Side
Side
TIP: Pull lower rack out, about halfway. Check
to be sure the rack does not roll forward or
back into dishwasher. If the rack rolls in either
direction, the dishwasher must be leveled
again.
• If the door hits the tub, the dishwasher is not
installed correctly. Adjust leveling legs to align
door to tub.
7