Table of Contents
Advertisement
S
S
UPER
ERVER 5018D-MF User's Manual
PCI Slot SMB Enable
2
Use Jumpers JI
C1/JI
SMB (System Management Bus) support
to improve system management for the
PCI-E slots. Default is disabled. See the
table on the right for jumper settings.
LAN Port Enable/Disable
Use JPL1/JPL2 to enable or disable LAN
Ports 1 and 2 on the motherboard. See
the table on the right for jumper settings.
The default setting is enabled.
BMC Enable/Disable
JPB is used to enable or disable the BMC
(Baseboard Management Control) chip
and the onboard IPMI connection. This
jumper is used together with the IPMI set-
tings in the BIOS. The default position is
on pins 1 and 2 to Enable BMC. See the
table on the right for jumper settings.
BIOS Recovery (JPBIOS1)
The BIOS Recovery (JBR1) is used to
enable or disable the BIOS Recovery
feature of the motherboard. Install the
jumper on pins 1-2 to begin the recovery
process.
Watch Dog Enable
Watch Dog is a system monitor that can
reboot the system when a software appli-
cation hangs. Close pins 1-2 of JWD1 to
reset the system if an application hangs.
Close pins 2-3 to generate a non-mask-
able interrupt signal for the application
that hangs. See the table on the right for
jumper settings. Watch Dog must also be
enabled in the BIOS.
2
C2 to enable PCI-E
5-22
PCI Slot SMB Enable/Disable
Jumper Settings
Setting
Defi nition
Closed
Enabled
Open (Default)
Disabled
LAN Port En/Disable
Jumper Settings
Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
BMC IPMI Enable/Disable
Jumper Settings
Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
BIOS Recovery
Jumper Settings
Setting
Defi nition
Pins 1-2
Normal
Pins 2-3
Recover
Watch Dog
Jumper Settings
Setting
Defi nition
Pins 1-2
Reset (default)
Pins 2-3
NMI
Open
Disabled
Advertisement
Table of Contents
