Table of Contents
Advertisement
LIGHTING INSTRUCTIONS GRILL / ROTISSERIE
Section Four:
You'll hear a snapping sound.At the same time, a spark
will be provided at the safety probe. Hold the safety
valve button in for about 5 seconds or until the burner
remains lit.
This is the only burner on the grill with a safety valve.
Once lit, turn control knob to desired setting. If the
burner does not light within 4 seconds, release the
safety valve button and turn the control knob to "OFF".
If the igniter does not function, the burner can be lit by
holding a lit match to the burner with the control knob
at "LITE" and the safety valve button pressed.
Section Five:
WARNING: IMPORTANT!
USING THE SIDE BURNER:
Inspect the gas supply piping or hose prior to turning
the gas "ON". If there is evidence of cuts, wear or
abrasion, it must be replaced prior to use. Do not use
the side burner if the odor of gas is present.
WARNING: Always keep your face and
body as far away from the burner as
possible when lighting.
LIGHTING INSTRUCTIONS:
To light side burner, remove any cooking utensils from
the burner grate. Push and turn the control knob
counterclockwise to the "LITE" position.This will start
the gas flowing.
Turn the rotary spark igniter clockwise next to the
burner knob. You'll hear a snapping sound.At the same
time a spark will be provided at the burner igniter. It
may be necessary to turn the rotary spark igniter knob
several times until gas has filled the line. If the smell of
gas is detected and the igniter is not functioning,
immediately turn the control knob "OFF".
Allow 5 minutes for any accumulated gas to dissipate,
then see the following section for "MATCH LIGHTING".
USING THE SIDE BURNER
13
Always ensure that the burner is properly
resting on the orifice prior to lighting the
burner.
Keep a spray bottle of soapy water near
the gas supply valve and check the
connections before each use.
Do not attempt to "LITE" the grill if the
odor of gas is present. Call for service
1-800-305-2557
MATCH LIGHTING:
Hold a lit match near the burner ports, turn the control
knob counterclockwise to "LITE". Move your hand
immediately once the burner is lit. Rotate the control
knob to the desired setting. Check for proper burner
flame characteristics and adjust the air shutters if
necessary. Each burner is adjusted prior to shipment;
however, variations in the local gas supply may make
minor adjustments necessary.
CAUTION: Wait for the burner to cool
before making adjustments.
Burner flames should be blue and stable with no yellow
tips, excessive noise, or lifting. If any of these conditions
exist check that the air shutter or burner ports are not
blocked. If the flame is yellow, indicating insufficient
air, turn the air shutter counterclockwise to allow more
air into the burner. If the flame is noisy and tends to lift
away from the burner, indicating too much air, turn the
air shutter clockwise to reduce the air opening. To
access the open
burner air shutter,
remove the burner
grate.The locking
screw is on top of
the venturi, loosen,
adjust, retighten.
Burner
Ports
FIG.21
Hide quick links:
Advertisement
Table of Contents
