Lap-Shoulder Belt Installation - Britax Roundabout User Manual

Forward Facing Installation
Forward Facing

Lap-Shoulder Belt Installation

• Figure A illustrates a typical forward facing
Lap-shoulder belt installation.
• When installing with vehicle belt, store
LATCH connectors in storage slots under
cover. See page 21.
Place the child restraint forward facing
1
on the vehicle seat.
• Installation can be improved by the use of
®
the Versa-Tether (see pages 23–25).
Pull the vehicle belt out, then pass it
2
through both forward facing belt slots
(Fig. B).
Verify that the vehicle belt is not
3
twisted, then buckle (Fig. C).
18
A
B
C
4 Press the lock-off to open (Fig. D).
• Only use lock-off farthest from
where the vehicle belt is buckled.
5 Kneel on the child restraint with
full weight to force it into the
vehicle seat while pulling the
shoulder portion of the vehicle
belt tightly through the lock-off
to remove slack.
Hold the shoulder belt tight, then rotate the lock-off into the belt
6
until it clicks in place.
• Lock-off is not engaged and vehicle belt is not secured until a click
is heard.
Verify that the vehicle belt is tight and the child restraint is secure.
7
• See Checking Buckle Position on Page 26.
Removal
Open lock-offs, then unbuckle and remove vehicle belt from belt
path. Disconnect Versa-Tether
Forward Facing Installation
D
, if attached.
®
19