Table of Contents
Advertisement
The display is protected by a plastic film.
Remove the protective plastic film!
Inserting the batteries
G
Insert the batteries ensuring correct polarity – see figure on left.
G
Replace cover and push gently upward until it clicks into place.
G
To open, press the grooved area on the cover and slide down.
½
G
Only insert the recommended rechargeable batteries (see
page 45). Never use ordinary (non-rechargeable) batteries as
they may pose a health hazard or cause injury.
G
Never use non-Siemens charging units as these can damage
the batteries.
k
Placing the handset into the base station and charging the
batteries
Ö
Before activating your handset, place it in the base station with the
display facing upward. After approx. one minute, the handset's in-
ternal number is shown in the top left-hand corner of the display (e.g.
"1").
½
For information on how to register further handsets (bought
additionally), see page 26.
Leave the handset for approx. five hours in the base station to charge
5 h
the batteries. The charging status icon flashes on the handset indicat-
ing that the batteries are being charged:
Ý
Batt. empty (symbol flashes)
Ü
Batteries
Note:
Your device is now ready for operation. Please set the date and the
time (see page 9), so that the time of incoming calls can be noted
correctly.
1
/
charged
3
Preparing the telephone
Û
2
Batt.
/
charged
3
Ú
Batt. fully charged
7
Advertisement
Table of Contents
