P10 MALE – P11 FEMALE............... 25 P12 HEART ..................27 P13 WATT RATE ................30 Symbols and their Meanings ............31 Program Profiles ................... 33 WARRANTY ....................34 This manual is compatible with software versions 2.0 and 2.1. Page 1 BH Fitness SK9900...
14. Disabled people should not use the exercise equipment without the assistance of a qualified person or a doctor. 15. Do not use the exercise equipment if it is not working correctly. SAVE THESE INSTRUCTIONS FOR FUTURE USE. Page 2 BH Fitness SK9900...
Page 8
Fasten using flat washers (LL), grower washers (L) and screws (K). 4. FIT THE FRONT TRIM COVER Figure 3. Fit the front trim cover (C) by sliding it onto the side tubes. Install and tighten screw (I) to secure the cover. Page 7 BH Fitness SK9900...
Page 9
Connect the plug end of the AC/DC adapter (N) into a 110-120V outlet. NOTE: This unit is equipped with a generator (dynamo) that converts the mechanical rotation (produced by the exercising user) into current (electrical energy) to power the electronic monitor and brake controller. Page 8 BH Fitness SK9900...
Page 10
If the battery runs down, it can be recharged by using the 15V Adapter (N) that is supplied with the unit. BH RESERVES THE RIGHT TO MODIFY THE SPECIFICATIONS OF ITS PRODUCTS WITHOUT PRIOR NOTICE Page 9 BH Fitness SK9900...
Page 13
IMPORTANT: TO ENSURE THAT THE BATTERIES OPERATE CORRECTLY AND LAST LONGER, RECHARGE THEM USING THE 15V ADAPTER (N) SUPPLIED WITH THE UNIT. Page 12 BH Fitness SK9900...
CALORIES: This shows the estimated number of calories that have been burned off up until now. This calculation is based on the energy being produced and the weight and age values provided by the user. Page 13 BH Fitness SK9900...
Page 15
Pause will only last for 45 seconds, then the exercise will stop and the monitor will exit the exercise. If, the STOP key is pressed, in pause mode, then the exercise will finish. Page 14 BH Fitness SK9900...
Page 16
The ON personalized power option may be changed to OFF. QUICK / START - Quick start key. When this key is pressed, provided that the LED on the key is flashing, exercise will begin in manual mode. Page 15 BH Fitness SK9900...
This mode is activated if an RPM signal is not received within 45 seconds when in stand-by mode. Windows are not displayed while in this mode. You have to step on the footplate to produce a signal and reopen the display window. Page 16 BH Fitness SK9900...
Select the value 80 using the LEVEL ▲▼ keys. Press the ENTER key and the word “WHEELSIZE” will start flashing again. Press the LEVEL ▲ key to edit the “LANGUAGE”. If you wish to exit the personalization mode press the STOP key. Page 17 BH Fitness SK9900...
Page 19
Once you have selected this option, press the ENTER key and the word “POWER” will start flashing. Use the LEVEL ▲ key to edit the “SWR” time. If you wish to exit the personalization mode press the STOP key. Page 18 BH Fitness SK9900...
Page 20
LEVEL ▲▼ keys and then press ENTER to confirm. The word “MANUAL T” will start flashing again. Use the LEVEL ▲ key to edit the Welcome Message. If you wish to exit the personalization mode press the STOP key. Page 19 BH Fitness SK9900...
Page 21
Select the ON flashing value using the LEVEL ▲▼ keys and then press ENTER to confirm. The word “SOUNDS” will start flashing again. Press the STOP key to exit the personalization mode and the manual program will be displayed on the LED array (A). Page 20 BH Fitness SK9900...
Page 22
OFF (The welcome message is displayed by default) ON (Allows the welcome message to be edited) to personalize the welcome message. Sounds Enables or disables sounds (beeps) emitted by the monitor. Options: ON (Enabled) OFF (Disabled) Page 21 BH Fitness SK9900...
HHMMSS; DISTANCE COVERED ML; AVERAGE SPEED MLH; CALORIES BURNT KCAL will be displayed. If the keys are not touched and exercise does not occur while the average values are being displayed, then the “M” will appear on the top LED array. Page 22 BH Fitness SK9900...
HHMMSS; DISTANCE COVERED ML; AVERAGE SPEED MLH; CALORIES BURNT KCAL will be displayed. If the keys are not touched and exercise does not occur while the average values are being displayed, then the “M” will appear on the top LED array. Page 23 BH Fitness SK9900...
DISTANCE COVERED ML; AVERAGE SPEED MLH; CALORIES BURNT KCAL will be displayed. If the keys are not touched and exercise does not occur while the average values are being displayed, then the “M” will appear on the top LED array. Page 24 BH Fitness SK9900...
At the end of the 5 minute test you will be awarded a score between 1 (very poor) and 5 (excellent). A 0 score may also appear, which means that the test was not done correctly (the 75 rpm pedaling rate was not maintained or the heart rate measurement sensor was not used correctly). Page 25 BH Fitness SK9900...
Page 27
HHMMSS; DISTANCE COVERED ML; AVERAGE SPEED MLH; CALORIES BURNT KCAL will be displayed. If the keys are not touched and exercise does not occur while the average values are being displayed, then the “M” will appear on the top LED array. Page 26 BH Fitness SK9900...
With the monitor switched on, the top LED array ( A ), Figure 11, will display the profile and the letter “M” for manual. Use the LEVEL ▲▼ keys to select the ♥ (P12 HEART) program. Press the ENTER key. Page 27 BH Fitness SK9900...
Page 29
“M” will appear on the top LED array. AUTOMATIC EXERTION SETTING At the beginning of the exercise the machine sets the exertion level to minimum, i.e. 50W, until the first pulse reading is taken. Page 28 BH Fitness SK9900...
Page 30
If no heart rate is detected during the exercise, the “♥ ?” (Heart symbol and a question mark) will appear flashing. If this situation continues for more than 60 seconds the machine will go back to manual mode. Page 29 BH Fitness SK9900...
COVERED ML; AVERAGE SPEED MLH; CALORIES BURNT KCAL will be displayed. If the keys are not touched and exercise does not occur while the average values are being displayed, then the “M” will appear on the top LED array. Page 30 BH Fitness SK9900...
Spanner (wrench) symbol: Mechanical fault. Switch the machine off for 2 minutes and then switch it back on again. The machine has an automatic fault correction system, but if the problem persists, then contacts the technical service center. Page 31 BH Fitness SK9900...
Page 33
RETURN TO MANUAL MODE” “ DECREASE EXERTION OF EXERCISE. YOUR PULSE RATE IS TOO HIGH” “ THE RESULT OF THE TEST IS=” BH RESERVES THE RIGHT TO MODIFY THE SPECIFICATIONS OF ITS PRODUCTS WITHOUT PRIOR NOTICE Page 32 BH Fitness SK9900...
LABOR – 2 Years – (Home Warranty), 1 Year – (Light/Full Commercial Warranty) BH Fitness shall cover the labor cost for the repair of the device for a period of two years from the date of original purchase, so long as the device remains in the possession of the original owner for home use.
Need help?
Do you have a question about the SK-9900 and is the answer not in the manual?
Questions and answers