Speed Settings; Freewheel Operation; Illustration 11A And B - Brake Release Lever - Rascal Balance 600 B Owner's Manual

Speed Settings

The top forward/reverse speed of the vehicle is set by the Dial-A-Speed
knob on the dash. Lower settings, 1, 2 (indicated by the turtle symbol)
result in slower speeds. Higher settings 9-10 (indicated by the rabbit
symbol) provide faster speeds. When first operating your vehicle, select
slower settings to operate the unit until you feel comfortable.

Freewheel Operation

The scooter features a "freewheel" mode to allow it to be pushed manually
(push operation). To activate manually, turn the key switch OFF and locate
the brake release lever under the rear cover on the right side. Push lever
up to disengage the parking brake. Move lever down to engage the parking
brake. When your
regenerative brakes will not operate. The Brake Release lever is shown in
Illustration 11A and 11B.
DO NOT put Scooter in "FREEWHEEL" mode on an incline while seated.
11A
ILLUSTRATION 11A and 11B – Brake Release Lever
It is recommended to place lever back in the 'DRIVE' (down) position to
prevent the vehicle from rolling accidentally.
operate unless the Brake Lever is in the 'DRIVE' (lowered) position and the
Status Lamp does not flash indicating that the Brake Lever is in the DRIVE
Position.
Rascal 600B/700B Owner's Manual
vehicle is in
WARNING!
Drive
Position
EMC Part: 19278100 Rev. 3 ◦ 06/29/2009
manual push
11B
Note:
26
mode, parking
Push
Position
The vehicle will not
and