How Your System Reports Alarms; Silence Alarms - Bosch D621 Series User Manual

D621 Series | User's Guide | How Your System Reports Alarms

How Your System Reports Alarms

Your security system may be programmed to automatically
disconnect your telephone when sending reports to your
security company. Once the report is complete, the system
returns the telephone to normal operation (verify with your
installing company).
Your system makes repeated attempts to send reports to your
security company. If your system fails to report, the keypad
signals a system trouble. Refer to Check System Troubles on
page 37 for more information on determining the nature of
the trouble.
If your telephone service is interrupted, your
security system cannot send reports to your
security company unless it has an alternate
means of transmitting them.
Bosch Security Systems | 8/04 |

Silence Alarms

When there is an alarm, the alarm tone sounds and the
point(s) in alarm illuminate on the display. If you enter your
passcode before the system dials your security company, the
alarm report is aborted.
1. Enter your passcode to silence the alarm and turn the
system off (if it was turned on). An alarm report is sent if
not acknowledged in time.
2. Press and hold the [Cmd] key to remove the alarm(s)
(flashing point numbers) from the keypad display. Refer
to View Alarm Memory (Cmd 40) on page 38 to see which
points caused the alarm.
15