Turn The System Part On (Part On Or Cmd 2) - Bosch D621 Series User Manual

D621 Series | User's Guide | Turn The System Part On (Part On or Cmd 2)
Turn The System Part On (Part On or
Cmd 2)
I can perform this command.
o
I cannot perform this command.
o
You have __________ second(s) to exit premises before the
system turns on.
Part On turns on part of your system, leaving the rest of the
system turned off. Refer to the Point identification section of
your keypad reference card to identify Part points designated
for Part On activation.
Once you press the Part On key, the exit delay timer begins.
You should leave the premises before the exit time expires.
Leaving after exit delay expires starts an alarm event.
1. Make sure Part points are normal (not faulted).
2. Press [Part On]. The keypad may prompt you to enter a
valid passcode by flashing the Cmd indicator.
Bosch Security Systems | 8/04 |
3. Enter your passcode, if necessary. The Part On, Status,
and Cmd indicators light (Figure 9). If your system has a
faulted point (door or window open), you can either close
it or bypass it (refer to Bypass Points on page 27).
Figure 9: Part On Keypad Indication
1 2 3 4 5 6
9 10 11 12 13 14 15 16
If you wish, you can turn the system Part On with No
Delay by pressing [No Delay], or you may bypass points
by pressing [Bypass].
During the exit delay, you may stop the system from
turning on by entering your passcode.
All Status
7 8
Part Cmd
20